色婷婷国产精品无码视频,无码欧美毛片一区二区三,亚洲精品国产av在线小说,神马午夜福利在线观看久草

產品列表PRODUCTS LIST

首頁 > 技術與支持 > Cryo.STM凍存管使用方法
Cryo.STM凍存管使用方法
點擊次數:2842 更新時間:2022-07-04
Cryo.STM凍存管使用方法

Freezing protocol
冷凍步驟

1. Wash the cells with warm PBS solution, aspirate the solution and cover the cells with a solution containing trypsin and EDTA (a thin liquid film is enough; the concentration should be evaluated for each cell line).
用溫的 PBS 溶液洗滌細胞,吸取溶液,含有胰蛋白酶和 EDTA 的溶液覆蓋細胞(薄薄 的液層足夠了,胰蛋白酶和 EDTA 的濃度需要根據細胞系確定)。
2. Incubate the cells for max. 3 – 5 min at 37 °C.
37℃孵育細胞 3-5 分鐘。
3. Once the cells detach from the bottom, stop incubation by adding cell culture medium supplemented with serum and slightly suspend cells using a pipette.
細胞從底部脫離之后,終止孵育,加入含有血清的培養基,用移液器輕輕地懸浮細胞。
4. Spin down the suspension (500 x g, 5 min) and resuspend the pellet with medium containing serum.
離心細胞懸液(500 x g, 5 分鐘),用含有血清的培養基重新懸浮。
5. Determine the cell number (using a Neubauer chamber).
細胞計數。
6. Spin down the cells for 5 min at 500 x g and discard the supernatant. Resuspend the pellet with an adequate volume of cell culture medium containing serum.
離心細胞懸液(500 x g, 5 分鐘),去除上清液,用適量體積的含有血清的培養基重新 懸浮細胞。
7. Mix the cell suspension 1:1 with freezing medium (60 % medium, 20 % FCS, 20 % DMSO) and transfer it in Cryo.STM. For freezing in Cryo.STM the concentration of cells should be 1 – 5 x 106 cells / ml.
2/4 以 1:1 體積比混合細胞懸液和凍存液(60%培養基,20%胎牛血清,20% DMSO),然 后轉移到 Cryo.STM 凍存管中。凍存的細胞密度為 1-5×106 個/毫升。
8. Cryo.STM containing cells should be frozen at a cooling rate of -1 K / min. This can be achieved by placing them into an isopropanol-filled chamber at -70 °C. If other types of samples are contained, Cryo.s™ may be frozen directly at -20 °C, -70 °C or in the gas phase of liquid nitrogen. In order to assure even freezing of the sample, 4 and 5 ml Cryo.s™ should be frozen at -20 °C overnight before transferring them to -70 °C or to the gas phase of liquid nitrogen.
含有細胞的 Cryo.STM 凍存管建議以-1 K / min 的速率降溫,可以將凍存管置于-70℃含 有異丙醇的容器中。如果Cryo.STM凍存管含有其他樣品,可以直接放置在-20℃,-70℃ 或者液氮的氣相。為了確保樣品冷凍均勻,4 ml 和 5 ml 的 Cryo.STM凍存管需要先置于 在-20℃冰箱過夜,然后再轉移到-70℃或者液氮的氣相。
9. Then transfer the Cryo.STM into the nitrogen tank. To avoid contamination (e. g. mycoplasma) and due to safety precautions it is recommended to store the Cryo.STM in the gas phase above and not in the liquid nitrogen.
然后轉移 Cryo.STM 凍存管到液氮罐。為了避免污染(如支原體)和安全考慮,請將 Cryo.STM 凍存管置于液氮的氣相,切勿置于液相。

Thawing protocol
解凍步驟

1. Immediately after removing them out of the nitrogen tank the frozen cells are thawed in about 1 – 2 min brandishing the Cryo.STM in a water bath at 37 °C. The thawing process should be performed as fast as possible.
從液氮罐取出凍存的細胞后立即置于 37℃水浴搖晃 Cryo.STM 凍存管 1~2 分鐘。解凍 過程需要越快越好。
2. Transfer the thawed cell suspension into a 15 ml tube and mix it immediately with copious amounts of cell culture medium containing serum.
轉移解凍的細胞懸液于 15 mL 離心管,立即用大量的含有血清的細胞培養基混勻。 3/4
3. After spinning down the cells (500 x g, 5 min) discard the supernatant and resuspend the pellet in an appropriate cell culture medium supplemented with serum and transfer it into one or more cell culture flasks.
500 x g離心細胞5 分鐘,去除上清液,用適量的含有血清的細胞培養基重新懸浮細胞, 然后轉移到細胞培養瓶。
4. Follow the recommended cell concentration for seeding.
按照建議的細胞濃度接種。
5. During the next 12 hours cells should rest.
接下來的 12 小時細胞進入靜默期。
6. A change of medium is recommended after 24 resp. 48 hours.
間隔 24 小時和 48 小時更換培養基

Safety advisory for working with Cryo.STM
Cryo.STM凍存管安全操作建議


Cryo.STM tubes are intended for sample storage exclusively in the gas phase over liquid nitrogen or in freezers! If Cryo.STM are stored in the liquid phase, nitrogen can seep into the tubes. Then upon thawing the vaporizing nitrogen can generate high pressure, ultimately resulting in an explosion, as well as the release of any infectious material.
Cryo.STM凍存管用來存儲樣品,只能置于液氮氣相或冰箱。如果 Cryo.STM 凍存管浸沒于液 氮液相,液氮可能滲入凍存管。因此,解凍時,蒸發的液氮產生高壓力,最終導致凍存管炸 裂,并且還將導致感染物質釋放。
Always take appropriate personal safety measures when working with Cryo.STM, including wearing safety clothing, using goggles and working at a safety laboratory bench.
因此,操作 Cryo.STM 凍存管時需要佩戴合適的個人安全防護措施,如穿戴安全防護服、佩 戴護目鏡、在安全櫥操作。
When undertaking cryogenic preservation, Cryo.STM must be evenly exposed to freezing temperatures. Uneven temperature exposures can cause formation of ice plugs (i. e. at tube 4/4 top) that inhibit the expansion of freezing liquid (i. e. at tube bottom), resulting in dangerous high pressure and subsequent harm or damage of tubes.
進行冷凍保存時,Cryo.STM 凍存管需要緩慢地降溫至冷凍溫度。如果不是緩慢地降溫到冷 凍溫度,將導致冰塞形成(如在凍存管頂部),冰塞將阻礙液體形成凝固(如在凍存管頂 部),將導致高壓力危險和后續的爆管風險。
Never exceed maximum working volumes as specified.
不要超過標識的工作體積

欧美一区二区三区婷婷五| 国产A级理论片无码老男人| 九九视频精品在线免费观看| 精品一区二区三区三级视频| 久久亚洲中文字幕无码| 亚洲欧美日韩国产成人综合| 精品第一国产综合精品aⅴ| 欧美亚洲国产大片在线看| a人妻在线视频| 欧美一区二区三区在线播| 香蕉视频日本片在线观看| 2019国产品在线视频| 日本邪恶之一区精品久久| 亚洲制服中文丝日韩失禁| 久久99精品久久久久久野外 | 欧洲亚洲大片精品免费看| 91精品视频在线观看不卡| 一级片一区二区中文字幕| 亚洲精品亚洲精亚洲精品| 亚洲丝袜精品不卡一区二区| 在线精品国产91吴梦梦| 狠狠干天天婷婷婷婷婷婷| 最近中文字幕mv免费高清在线| 中国无码人妻丰满熟妇啪啪软件| 逼逼爱爱爱无码免费观看| 9999热精品免费视频| 操亚洲浪逼骚妇高潮视频| 亚洲国产亚洲综合欧美在线| 国产瑜伽XXX91在线| 亚洲人亚洲精品成人网站| 国产精品美女一区二区三区| 国内精品k频道国产网红| 99久久久无码国产aaa精品| 可以直接看的黄片一区二区| av在线观看亚洲一区二区| 成人综合亚洲综合自拍区| 九九99九九在线精品视频| 亚洲日韩精品久久久久久| 国产精品免费一区二区三区视频 | 在线观看高清不卡av片| 99热这里只有精品26|